240
TO LOGIN
Follow the steps below to open the Web Programming.
STEP 1: Start up
Internet browser on the PC.
STEP 2: Enter IP address of the target DT830 Series on the address toolbar and then press Enter key.
STEP 3: The Web Programming Login screen appears. Enter a user name (type “USER”) and a password, then click
.
Note:
Enter the password you assigned on the procedure “TO CHANGE PASSWORD”.
“0000” is used as password by the default setting.
Note:
For IP address of the terminal, contact the system administrator.
Note:
When the login screen does not appear, check the LAN connection status and entered IP address. If the problem
persists, please contact the system administrator.
To Next Page
Loading...
