NEC Univerge SV 9500 - Call Back; To Save and Repeat a Number

152
CALL BACK
If Called Station is Busy
STEP 1: Press the CALL BACK key. Receive a ser-
vice set tone.
– OR –
STEP 1: Press the Flash key and enter “Call Back” ac-
cess code.
STEP 2: When both parties become an idle state, call-
ing party's phone rings. Calling party would
go off hook and hear ring back tone.
The called station would then be ringing.
STEP 3: The connection is established when the
called party answers.
Using Soft Key
STEP 1: Press the CallBack soft key and receive a
service set tone.
STEP 2: “CALLBACK SET” is displayed and the Call-
Back soft key flashes on the display.
TO SAVE AND REPEAT A NUMBER
To Save
STEP 1: Press key.
STEP 2: Dial the desired telephone number.
STEP 3: Press the Save&Rep key. The dialed number
is now stored. The Save&Rep key’s LED
lights.
– OR –
STEP 3: Receive an internal call.
STEP 4: Press the Save&Rep key. The number is
stored in memory.
STEP 5: The Save&Rep key’s LED lights.
DT830
DT430/410
Called party
CALLBACK SET 2000
1:25 PM MON 11 MAY 2015
Called party
CALLBACK 2000
1:25 PM MON 11 MAY 2015
Called party
CALLBACK 2001
1:25 PM MON 11 MAY 2015
Note:
Call Back may be programmed by the Telephony
Server administrator on a Programmable feature
key or by the user on a One-Touch Speed Call-
ing key.
CALLBACK SET
Mic >>>
1:25 PM MON 11 MAY 2015
DT830
DT430/410
Speaker