100
MULTILINE OPERATION
You can answer an incoming call to the other station to
press the MULTILINE key (which is preassigned the
other station number).
To Originate a Call
STEP 1: Press the MULTILINE key.
STEP 2: Lift the handset or press key. Dial the
Central Office access code (i.e.9 (US), 0
(Aust)).
STEP 3: Dial the desired number.
To Answer a Call
STEP 1: Press the MULTILINE key (ringing and flash-
ing LED alert user to incoming call).
STEP 2: Lift the handset or press key.
STEP 3: Speak with the incoming party.
TO HOLD A CALL
STEP 1: Press key. The held line key wink
flashes.
To Retrieve
STEP 1: Lift the handset or press key.
STEP 2: Press the held line key. Use the handset to
converse.
If unanswered
STEP 1: After preprogrammed time, Automatic Recall
is initiated.
STEP 2: Visual and audible signal (rapid flash and ring
burst) is sent to the station that placed call on
hold.
Note:
If held line appears on other stations, the associ-
ated LED flashes red slowly.
Note:
Any station with this line key appearance can
retrieve the call.
Note:
Hold shows as a flashing green LED on your
phone. The same line on other phones shows as
a flashing red LED. Recall shows as a flashing
green LED on your phone and flashing red LED
on other phones with the same line.
Mic >>>
Held Station Number
2001
HOLD
1:25 PM MON 11 MAY 2015
To Next Page
Loading...
