NEC Univerge SV 9500 - Page 56

47
STEP 5: Select Automatic, Disable or En-
able (see the following table).
Select an item by either of the following operations.
• Highlight an item by using or the UP/DOWN soft
key, and then press or the OK soft key.
• Press - key, and then press or the OK
soft key.
• TO ENABLE/DISABLE DTMF TONE
The procedure below shows how to enable/disable
DTMF Tone.
STEP 1: Display the Menu screen, and select Setting.
STEP 2: Select User Setting.
Select an item by either of the following operations.
• Highlight an item by using or the UP/DOWN soft
key, and then press , or the OK soft key.
• Press key.
STEP 3: Select Talk.
Select an item by either of the following operations.
• Highlight an item by using or the UP/DOWN soft
key, and then press , or the OK soft key.
• Press key.
No. Menu Items Descriptions
0 Automatic
Follow the setting on the System.
If no setting is made in the Sys-
tem, the default setting
(Alarm=ON) is applied.
1 Disable
Follow the setting on the terminal
(OFF).
2 Enable
Follow the setting on the terminal
(ON).
Note:
For the setting on the System, contact the Sys-
tem administrator.
Note:
The enabled item is highlighted.
0
1
2
0
2
0
1
[RTP Alarm]
2
Automatic
OK
Back
Disable
Enable

1
1
1
2
Data Backup/Restore
[Setting]
3
Download
OKMenu

User Setting
2
2