NEC Univerge SV9100 - Keytelephone Access to System Settings; System Properties; Viopdb; IP Address

90
Issue 1.0
UNIVERGE SV9100
System Maintenance Manual
Keytelephone Access to System Settings
Various system details can be displayed at any display terminal.
System Properties
At the idle terminal:
Press Feature and then keypad digit 3
VERSION: 2.00.50
MAC: xx-xx-xx-xx-xx-xx
HKEY: nnnn-nnnn-nnnn
Version = Main Software version level installed onto the GCD-CP10
MAC = MAC address of the GCD-CP10
HKEY = Hardware Key of the GCD-CP10
VIOPDB
At the idle terminal:
Press Feature and then keypad digit 4
VoIP-E1 Slot 1 256
MAC: xx-xx-xx-xx-xx-xx
DSP: 000/000/256:0/0/0:0/0/0
VoIP = IPL Type Slot1 = GCD-CP10 256 = resources available
MAC = MAC address of the IPLE card
DSP =
If the IPLE card is not installed the display will show:
VoIPDB: Not Installed
MAC: xx-xx-xx-xx-xx-xx
DSP: 000/000/000:0/0/0:0/0/0
IP Address
At the idle terminal:
Press Feature and then keypad digit 6
IP Address Information
System: 192.168. 0. 10
VoIPDB: 172. 16. 0. 10
System = IP Address of the GCD-CP10
VoIPDB = IP Address of the IPLE card
This information is also available within the M=Navigation Key menu
System – Menu 820
VOIPDB – Menu 830
IP Address – Menu 840