Diagnostics
SECTION 1 WHAT IS AVAILABLE?
The SV9100 has a Diagnostic Interface Module (DIM) built into the
GCD-CP10 (CPU) blade. The DIM can monitor the activity of the system
under the control of commands
entered by the engineer. The DIM is
accessed via the Ethernet interface of the GCD-CP10 blade.
SECTION 2 BEFORE YOU START
As well as monitoring the system, the DIM can also be used to change the
operation of the system.
For this reason DO NOT enter the following commands, as they will cause
a system restart:
o
RESET
o
RESTART
o
SHUTDOWN
o
or any other command that looks like a reset request.
Some DIM commands give a real time output when the command is
entered, others will give an output until
you enter the command that turns it
off. You can turn on multiple DIM outputs by entering relevant
commands
one after the other.
The SV9100 will continue to operate normally with the DIM is running.
To Next Page
Loading...
