NEC Univerge SV9100

System Maintenance Manual
UNIVERGE SV9100
Issue 1.0
31
SECTION 6 COMMON DIM COMMANDS
Enter
Function
DIM Output
Mail in 0 0 0 0
Output of all system activity is
turned on.
No ISDN information output.
Enter CAPS debug mode.
The activity of all extensions and lines is
output.
Mail in 0 0 0 0
Output of all system activity is
turned off.
Exit CAPS debug mode.
Enter
Function
DIM Output
Mail in 0 0 1 2
Output of all ISDN activity on
the system is turned on.
Enter ISDN debug mode. master current bid
: xxH master current line : xxH
The activity of all ISDN blades will be output.
Mail in 0 0 1 2
Output of all ISDN activity on
the system is turned off.
Exit ISDN debug mode.
 When the ISDN output is turned on, the DIM will output the ISDN blade slot and circuit that is
currently set as the master clock for the system.
 The slot number is shown by master current bid : xxH (xx is the slot number in hexadecimal).
 The circuit of the blade is shown by master current line : xxH (xx is the circuit number in hexadecimal).