NEC Univerge SV9100 - Sv9100 Net DIM Commands

System Maintenance Manual
UNIVERGE SV9100
Issue 1.0
33
SECTION 7 SV9100 NET DIM COMMANDS
Enter
Function
DIM Output
NWINFO
Lists the
NWINFO
DEBUG
Networking Debug Information [ON|OFF]
commands
NWINFO
RSRC
Netport Reosurce Controller
available
NWINFO
BLF
Blf Memory Dump
NWINFO
TCPINIT
Dummy CR data send Task refresh
NWINFO
TCPDEBUG
Networking TCP Information Debug
[ON|OFF]
NWINFO
TCPSHOW
Networking TCP Information showing
NWINFO
CALLINFO
Networking Call Status Information
NWINFO
KEEPALIVE
Networking KeepAlive Information
NWINFO
SYSTEM
Networking System Information
NWINFO
OPCHG
Networking error operation change
NWINFO
PARKHOLD
Parkhold debug information
NWINFO
CALLID
Networking CallID mode selection
NWINFO
CHSHOW
Show ch condition LED on Dterm
NWINFO
ROAMING
PHS Roaming Debug
NWINFO
TASKINIT
NwInfoSend task initialize
NWINFO
TASKKP
Nwsend Task Keepalive setting
NWINFO
VMI
Remote VMI information
To display the syntax for each command – type in the command. Example:
nwinfo parkhold
NWINFO PARKHOLD DEL Deletes the specified parkhold
NWINFO PARKHOLD SHOW Shows the specified parkhold information
NWINFO PARKHOLD MODE Changes Networking Parkhold mode [RUN|STOP]
NWINFO PARKHOLD DEBUG Park Hold Trace Information [ON|OFF]
NWINFO PARKHOLD CLEAR Park Hold Clear at All of systems
NWINFO PARKHOLD DEL <park group no> <park orbit>
(The values within the brackets are the specific number related to the command, the brackets are not
entered.)
In the NWINFO PARKHOLD DEL command to delete park hold orbit 04 that is within park group 01 you
would enter: nwinfo parkhold del 01 04
nwinfo debug on should only be used in the lab (or after normal working hours at a customer site), as it
causes a large amount of information to be output and can slow the SV9100.