NEC Univerge SV9100 - Page 46

Issue 1.0
UNIVERGE SV9100
34
System Maintenance Manual
o Date
Enter
Function
DIM Output
date
Displays the current date /
time and general system
information including
GCD-CP10 software version
and PAL type.
Current date/time : 1-1-2002 (TUE) 0:17:41
System build date : Jul 16 2004 16:56:25
[Target is North America (Electra)]
Main software version : 00.1u PAL TYPE : V-
PALB
FPGA version : 001FH CCPU-DSP version :
7628H DSPDBU version : 0000H
MAC1 Address : 00-60-B9-01- MAC2 Address :
00-60-B9-01-FD-3B
C/C++ library heap 112945388Bytes free
[Total=118132660Bytes,
Used=5187272Bytes]
Maximum intervals): Drivers : 0.11sec. H
levels : 0.11sec. B levels : 0.16sec. Mail
tasks : 1.01sec. Idle tasks : 5.45sec.
o Status
Enter
Function
DIM Output
status
List the status
commands available.
STATUS logical_port(HEX) STATUS [STA|TRK |VRS]
<start_serial_port(HEX)><end_serial_port(HEX)>
STATUS SET <logical_port(HEX)> <new_status (HEX)
m To display the status of one port:
status llnnnn
Where ll is the logical port type and nnnn is the port number in hexadecimal. (example – to display the status of
key telephone port 10 = status 04000a)
m To display the status of a range of ports:
status sta/trk nnnn nnnn
Where ll is the logical port type and nn is the port number in hexadecimal. (example – to display the status of
extension ports 01 through to 16 = status sta 0001 000f)