NEC Univerge SV9100 - To Log on to the DIM

System Maintenance Manual
UNIVERGE SV9100
Issue 1.0
23
The SV9100 GCD-CP10 can slow down when the DIM is running on a busy SV9100 system. This is
unavoidable, as the GCD-CP10 must process all system activity and output the corresponding information to
the DIM.
SECTION 3 TO LOG ON TO THE DIM
Access to the DIM has changed from the SV8100 in the following way:
 Access via port number 5963 is not available, this has been completely removed and cannot
be enabled.
 User ID monimoni and password hihi are not available.
 Access must now be enabled on each system via the user access to the DIM.
User Access to the DIM
PRG Command setup
10-20-06 – DIM Output – Enter the TCP Port for DIM Access (eg 5964)
90-31-01 – Enable DIM access
Username (default = SV9100)
Password (default = 12345678)
Easy Edit
Advanced Items – Maintenance – DIM Access Password
Note - It is strongly recommended that you change the default username and password after
enabling DIM access.