System Maintenance Manual
Real unit ID : 12H
Version
: 1.8 Firmware loaded onto the Blade
Lines / unit : 8 Number of ports on the card (8ESIU)
Block switch : RUN Block switch set to RUN
Timeslot : 000H-00FH (16)
slot info 03
Slot information)
Slot ID : 3
Status : RUNNING
Logical unit ID : BRIU
Dump down message : Disable
Number of Tx errors : 0
Slot started delay : 468.99sec.
Common unit driver information)
Slot ID : 3
Real unit ID : 60H
Version
: 3.3 Firmware loaded onto the blade
Lines / unit : 2 Number of ports on the card (2BRIU)
Block switch : BLOCK Block switch set to BLOCK
Timeslot : 040H-043H (4)
BRIU driver information)
m
To reset the Blade installed in a slot:
slot reset nn
Where nn is the slot number 01 to 10 in hexadecimal.
The Blade is reset, any calls in progress at the Blade are disconnected.
The Blade operates normally after the
reset.
The reset has the same operation as removing and re-installing the Blade.
(example – to reset the Blade in slot 3 = slot reset 03)
o
Detector
List the status of the
DTMF/Tone detectors on
the GCD-CP10(and DSPDB
if
installed).
Number of Channels = 64
CPRU = 32 , DSPDBU
= 32
No Type Status
Target
01(1401) DTMF
ACTIVE
000d
02(0000) NOT USED
READY
0000
03(0000) NOT USED
READY
0000
04(0000) NOT USED
READY
0000
05(0000) NOT USED
READY
0000
: : :
:
64(0000) NOT USED
READY
0000
To Next Page
Loading...
