NEC Univerge SV9500 - Page 55

47
STEP 5: Select Automatic, Disable or En-
able (see the following table).
Select an item by one of the following operations.
• Highlight an item by using or UP/DOWN soft key,
and press or OK.
• Press - , and press or OK.
• TO ENABLE/DISABLE DTMF TONE
The procedure below shows how to enable/disable
DTMF Tone.
STEP 1: Display the Menu screen, and select Setting.
STEP 2: Select User Setting.
Select an item by one of the following operations.
• Highlight an item by using or UP/DOWN soft key,
and press , or OK.
• Press .
STEP 3: Select Talk.
Select an item by one of the following operations.
• Highlight an item by using or UP/DOWN soft key,
and press , or OK.
• Press .
No.
Menu
Items
Descriptions
0 Automatic
Follow the setting on the System. If no
setting is made in the System, the
default setting (Alarm=ON) is applied.
1 Disable
Follow the setting on the terminal
(OFF).
2 Enable
Follow the setting on the terminal
(ON).
TIP
For the setting on the System, contact the System
Administrator.
TIP
Default setting is Automatic.
TIP
The enabled item is highlighted.
0
1
2
0
2
0
1

1/1
Automatic
OKBack
Disable
[RTP Alarm]
2
Enable
1
1

Menu
OK
1
2
Data Backup/Restore
[Setting]
3
Download
User Setting
1/1
2
2