2-22 Using the Hardware
External Monitor
You can add a standard external monitor to your NEC
Versa 4000. You need a display signal cable (usually pro-
vided with the monitor). One end of the cable must have a
15-pin connector for the system.
Follow these steps to connect an external monitor to your
NEC Versa 4000.
1. Check that the NEC Versa is in Suspend mode or pow-
ered off and the monitor power switch is turned off.
NOTE
The NEC Versa must be in Suspend mode or
powered off while the monitor is being connected.
2. Open the port cover on the back of the system.
3. Attach the 15-pin cable connector to the monitor port
on the system. Secure the cable connection with the
screws provided.
Connecting a monitor
Monitor Port
To Next Page
Loading...
