NEC VERSA 4000 - Page 72

5-4 Solving Problems
POST Error Messages
MESSAGE WHAT TO DO
Diskette drive A or B
failure
or
Drive A does not work or is not properly connected.
Drive A is the diskette drive.
No Floppy Drive Check that drive A is securely connected and power
is on.
Press F2 to start Setup to check the diskette drive
parameters.
If there’s still a problem, the drive might need repair.
General Failure
Reading Drive A
or
Diskette Read Failure –
press
F2 to run Setup.
Press any other key to
retry boot
Remove the diskette from drive A and press
F2 to
start the system from the hard disk.
Or, insert a bootable disk in drive A and press
F2.
Non-system disk or
disk error; Replace
and press any key
when ready
Remove the diskette from drive A and press any
key to start the system from the hard disk.
Or, insert a bootable disk in drive A and press
any key.
Operating System Not
Found
or
Fixed Disk Failure 0
Press F2 to start Setup. Change the hard disk type to
the correct setting. Exit and save Setup changes.
Invalid configuration
information – run Setup
program
One or more system configuration parameters
are not properly set. Start Setup, set them correctly,
and exit and save to update the parameters.
Real time clock
failure
Set time and date using Setup. Exit and save to
update the parameters.
Time-of-day not set –
run Setup
Set the time and date using Setup. Exit and save
Setup changes to update the parameters.