NEC XN120 - 1 Introduction

XN120 PC Programming Tool
3
1. Introduction
This guide explains the installation and operation of the XN120 PC programming tool (PCPro).
With PCPro you will be able to create a new customer configuration off line and upload to an
XN120 system.
You can also download whole or parts of the XN120 configuration for editing or backup.
We also provide some Pre Config files that are intended to be used by installers that are not
familiar with the XN120 system. These have the basic settings for a ‘typical customer’ and
enable the installer to quickly setup the XN120 system for either analogue trunk or ISDN DDI
working.
The guide covers the following main points.
1. Installing the XN120 PCPro programming tool
2. Connecting your PC to the XN120
3. Setting the IP address of your PC’s NIC
4. Upload/Downloading the XN120 configuration
5. Loading the Pre Config files
6. How to edit program commands from Pre Config Data.
Pre Config files
These files contain UK set up and basic operation, designed to create a starting point for all
new installs
Once uploaded the XN120 should only require minimal changes to meet the customer’s
requirements.
At the end of this guide both Pre Config files are detailed, showing the changes from a
Default XN120 system.
Changing the Pre Config Files
All commands have been changed within the Pre Config files are detailed in this guide along
with screen shots from PCPro.
The screen shots show the Pre Config data. (Starting data).
Each command details how to navigate to each program and which part should be edited
editing.
Pre Config data can be edited and saved without being connected to system (off line).
Programming numbers are also included that act as quick reference for editing the config at a
later date (or editing via the system phone as the programming numbers are the same).