NEC XN120 - Setting up TCP;IP Addressing on Your PC

Setting up TCP/IP Addressing on your PC
8
Setting up TCP/IP Addressing on your PC
You will need to setup the NIC on your PC before you can communicate with the Ethernet port
on the EXIFU card. The setting will be different, depending on your connection method; via
LAN cross cable or via the customer LAN.
If you have a new XN120 system (at default) it will have:
IP address = 172.16.0.10
Sub Net Mask = 255.255.0.0
These are set by program 10-12-01 on the XN120.
Your NIC card must have a fixed IP address within the range 172.16.0.11 to 172.16.254.254
and a suitable sub net mask.
If the EXIFU is connected to the customers LAN then the IP address of the XN120 will be
within the range of the customers LAN. You will need to confirm your NIC settings with the
network administrator.
The IP address of the XN120 is set by Program 10-12-01, you will need this when you connect
to the XN120 via PCPro.
Procedure
*The following windows are using Windows 2000 professional.
1. Click START-> SETTING-> NETWORK CONNECTIONS
(Network and Dial-up Connection). The following Windows appears.
2. Right-Click on the LOCAL AREA CONNECTION Icon and Click on PROPERTIES.