NEC XN120 - 2 XN120 PC Programming Tool; Installing the XN120 Programming Tool

XN120 PC Programming Tool
4
2. XN120 PC Programming Tool
Installing the XN120 programming tool
Minimum Requirements
The Topaz PCPro will be installed into the following PC specifications;
1 Processor Pentium II 500MHz equivalent or higher
2 RAM 128MB
3 Hard Disk Drive
Space
20MB
4 Monitor Resolution 800 X 600 pixels or higher
5 OS
(Operating System)
Microsoft Windows 98SE/2000/XP
6 Drive CD-ROM Drive
Mouse
7 Others
(depending on connection type)
NIC - Network Interface Card
Serial COM port
Important Points
1. Only one person is allowed in programming mode at a time. An error message will be
received if trying to log on while another user is already in programming mode.
2. When updating the PCPro software, it is recommended that you should first remove the
existing software version.
3. After connect PC with Topaz System, if nothing is carried out about 15 minutes, a session
will be cut off by Topaz main software.
Procedure
1. Insert the XN120 Technical Support CD into the CD-ROM Drive of your PC.
2. From My Computer, Click CD drive and Click“ Setup exe” to start the installation.
3. Click Next> to appear the License Agreement. Click Check box.