NEC XN120 - Caller ID (CLI) Analogue Trunks

Making Changes to the Configuration
70
Caller ID (CLI) Analogue Trunks
Description
CLI from Network supplier appears on handsets before answering call.
Matched with Abbreviated numbers (13-04-01) will also show Name (13-04-02).
Important
This feature needs to be activated by Network supplier (BT)
When is feature is set on XN120 it searches for CLI information.
If Network supplier does not send CLI, incoming calls will be delayed.
Call will appear to hang for 5 to 10 seconds before presenting call.
This is not a fault with XN120
IF THIS HAPPENS, PROGRAM STEP MUST BE DISABLED
Pre config - initial data
Network CLI not set
Options
Enabled / Disabled
Procedure
1. Click on 14-xx to expand tree
2. Click on 14-02
3. Locate Trunk
4. Change - Item 10 – Enable
5. Edit all analogue trunks
6. Save changes (Apply)
7. Click 14-xx to close tree
Alog pre
config
✔
ISDN pre
config