P285U00
05 - 2007
TECHNICIAN MENU
16
2.1.2 - COIN MECHANISM
2.1.2.1 - COIN MECH. SET.
2.1.2
coIn mechanISmS
2.1.2.1
SettIng the coIn mechanISmS
It is possible to decide which of the payment system protocols
available are to be enabled for the functions.
The available payment systems are:
- Executive
- Validators
- BDV
- MDB
By selecting one of the systems it is possible to control its
functions.
Executive
The following payments systems are available for the Executive
system:
- Standard
- Price Holding
- Coges
- U-Key
- Sida
Validators
When the “Validator Lines” function (line programming) of the
“programming” menu is displayed, the value of the 6 Validator coin
lines, A to F, can be changed.
BDV
The BDV protocol menus are used for dening the following
functions:
Type of vending
Setting the operating mode for multiple or single dispensing. With
multiple dispensing, the change is not automatically returned after
a successful selection; however the credit is available for further
selections. When pressing the coin return button, the available
credit is returned if its value is lower than the maximum change
value.
Change control
This function enables/disables the return of credit if no selections
are made.
If enabled, this function allows the return of coins even if the rst
selection was not dispensed.
If however a selection fails for any reason, the change will be re-
turned if requested.
Maximum credit
This function is used to dene the maximum accepted credit.
Maximum change
It is possible to set a limit to the total amount of change returned by
the coin mechanism when pressing the coin return button or after a
single dispensing serving.
Any credit exceeding the amount programmed with this function
will be cashed.
Accepted coins
It is possible to dene which, among the coins recognised by the
validator, are to be accepted.
Check the label on the coin mechanism for the correct coin to
value matching, indicating the position of the coins.
VAlIDATORI
BDV
To Next Page
Loading...
Need help?
General
