Necta Kobalto - Initialising the Data Base; Steam Boiler

P285U00
05 - 2007
TECHNICIAN MENU
43
5.2 - INITIAlISING DB
5.2
InItIalISIng the data-baSe
This function is used for “initialising” the machine, resetting all data
to default values. This function should be used if there is a memory
data error or when the software is replaced. Except for the general
electronic counter, all statistical data is reset.
When conrming this function some parameter settings are re-
quested, and namely:
- COUNTRY
Intended as type of basic doses for the different selections. The
available “countries” vary according to the models.
- LAYOUT
A number of Button/Selection combinations to choose from is
provided for each dose type model (the combinations available for
each layout are indicated in the dose selection table supplied with
the machine).
- TANK
Dening whether the water supply is:
0 - from the mains
1 - from an internal tank
2 - from two internal tanks
- STEAM BOILER
Dening the operation (if present) of the steam boiler:
ON - enabled
OFF - disabled
When conrming the options the message “Working” is shown on
the display for a few seconds.