P285U00
05 - 2007
TECHNICIAN MENU
46
6
gSm
The control software can send, via GSM modem, a signal indicat-
ing a machine failure or an “ending product” “pre-alarm”, after
dispensing a certain (programmable) number of selections of a
given product.
6.1
gSm pIn code
This function is used for programming the identication code that
will be sent to the GSM modem (optional) when switching the
machine on.
6.2
gSm pre-alarmS
6.2.1
pre-alarmS threSholdS
This function is used for dening the number of pieces or grams of
powder for a given product, after which a “running-out” “pre-alarm”
is signalled via modem.
6.2.2
reSettIng the pre-alarm counterS
With this function the counters that control the pre-alarms are
reset.
6.3
bank number
The number in the bank of machines (1 to 7) that identies the
machines that have the “slave GSM” function, therefore sending
data via the “master” machine modem .
The number 0 identies the machine that is connected directly to
the modem, i.e. the “master GSM”.
6 - GSM
6.1 - GSM PIN CODE
6.2 - GSM PRE-AlARMS
6.2.1 - SET GSM THRESH.
6.2.2 - RES PRE-AlM CNT.
6.3 - GROUP NUMBER