Necta Kobalto - Pre-Grinding; Counter Maximum Number; Espresso Unit Heating; Enable no Coffee

P285U00
05 - 2007
TECHNICIAN MENU
25
2.3.A - PREGRINDING
2.3.B - CNT MAX NUMBER
2.3.C - EN. HEATING ES
2.3.D - EN. EMPTY COFFEE
2.3.a
pre-grIndIng
This function is used for enabling/disabling the grinding of coffee
for the next selection. This permits the reduction of dispensing time
for a coffee selection. The function is disabled by default.
2.3.
b
counter maxImum number
This function is used for setting the maximum number of selec-
tions to be reached for the purpose of disabling the machine. The
counters can be set for the following selections:
- Espresso
- Instant
- Espresso + Instant
When setting a new value for the counter, the previous count is
cancelled.
This function is active if the counter reset password was set before
hand.
2.3.
c
eSpreSSo unIt heatIng
If the vending machine has not dispensed espresso coffee-based
drinks for a certain period of time, this function enables the possi-
bility of choosing whether or not heat the unit by dispensing a small
amount of hot water.
The cycle is conrmed in normal vending mode through the illumi-
nated buttons.
2.3.
d
enable no coffee
This function is used for enabling the “No coffee” warning through
the message on the display “Insert coffee” and for disabling the
coffee-based selections.
In the event more than one coffee grinder are present in the ma-
chine, they will be indicated as follows:
“M1, M2” with a bullet next to each name, the empty bullet indi-
cates the “no coffee” status.