P285U00
05 - 2007
TECHNICIAN MENU
20
2.2.1.2 - SET WHIP DOSES
2.2.1.2.1 - SET WHIP DOSES
2.2.1.2.2 - SET MODAlITY
2.2.1.3 - El.VAlVE SETTING
2.2.1.4 - SET DRIPPING
2.2.1.5 - SET STEPPED WATER
2.2.1.2
SettIng the WhIpper
2.2.1.2.1
SettIng the WhIpper doSeS
The whipping time can be set for each selection button, for each
water dose that composes such selection.
The duration can be set in two different modes:
2.2.1.2.2
SettIng the WhIpper mode
It is possible to choose between two different modes:
Absolute
i.e. independent from the solenoid valve opening time. The whip-
ping duration is set as tenths of a second for Instant models and as
volumetric counter pulses for Espresso models.
Relative
i.e. based on the difference, plus or minus, from the moment the
solenoid valve closes.
The whipping duration is always expressed in tenths of a second.
2.2.1.3
SolenoId valve SettIngS
It is possible to set the water ow rate of the single solenoid valves
expressed in cc/s (the default value setting in cc/s is indicated in
the selection dose table) to calculate the amount of water to be
dispensed.
2.2.1.4
SettIng the drIppIng
The wait time (programmable from 0 to 2000 hundredths of a sec-
ond) to the emission of an “end of dispensing” warning sound can
be set for each selection in order to allow the tubes to drain.
2.2.1.5
Stepped dISpenSIng of Water
This function is used for setting, for each instant product selection,
the intermittence time of opening the solenoid valves, in order to
adapt the effective ow to the dispensing time.
With the value set to 100 the solenoid valve is open continuously.
The intermittence is programmable from 50 to 80 hundredths of a
second for each second of water dispensing.
To Next Page
Loading...
Need help?
General
