P285U00
05 - 2007
TECHNICIAN MENU
22
2.2.2 - SET POWDER
2.2.2.1 - POWDER DOSES
2.2.2.2 - SET POWDER CYClES
2.2.2.3 - DOSER SETTING
2.2.2.4 - Gl. POWDER DOSES
2.2.3 - SElECTION STATUS
2.2.4 - SEl. <-> BUTTON
2.2.2
SettIng the poWderS
2.2.2.1
poWder doSeS
This function is used for setting, for each selection button, the
instant product powder doses that compose the drink.
These are expressed in gr. (grams).
The display will indicate the combination of water and powder
being set (water 1 - powder 1, etc.) and the powder dose value
blinking. In order to verify the correct correspondence refer to the
“Selection dose table”.
2.2.2.2
SettIng the poWder cycleS
This function is used for setting, for each selection, the number of
steps or the decaffeinated cycle for dispensing the powder, for the
purpose of improving the appearance of the drink.
2.2.2.3
Setting the DoSer unitS
This function is used for setting the ow rate of the single doser
units, expressed in g/s, to calculate the amount of powder to be
dispensed, for correct conversion of product dose values.
2.2.2.4
global poWder doSeS
This function is used for programming the doses of a product
“Globally”, i.e. setting all selections with a single operation.
2.2.3
SelectIon StatuS
Each single selection button can either be enabled or disabled.
2.2.4
button <--> SelectIon
This function permits the association of a selection number, indi-
cated in the selection dose table, to a button in the direct selection
keypad.
To Next Page
Loading...
Need help?
General
