Necta Kobalto User Manual

P285U00
05 - 2007
TECHNICIAN MENU
19
2.1.2.2 - IMMEDIATE CHANGE
2.1.3 - DECIMAl POINT
2.2 - SElECTIONS
2.2.1 - SET WATER
2.2.1.1 - WATER DOSES
2.1.2.2
ImmedIate change
This function is valid only in the case where a change-giver coin
mechanism is installed in the machine.
Normally the amount for a selection is cashed after the machine
sends the message “Selection successful”, consequently the
change is given at the end of dispensing the selected product.
By enabling this function, disabled by default, the cashed signal is
sent at the beginning of dispensing, consequently the change owed
to the user is given at the same time of dispensing the product.
2.1.3
decImal poInt
Press the conrm button “

” to display the position of the decimal
point, i.e.:
0 decimal point disabled
1 XXX.X
2 XX.XX
3 X.XXX
Press the conrm button “

”, these values will start blinking and
can then be modied as necessary.
2.2
SelectIonS
2.2.1
SettIng the Water
2.2.1.1
Water doSeS
With this function the water doses that compose the drink can be
set for each selection button.
These are expressed in:
- cc for instant products;
- fmp (number of pulses of the volumetric counter) for Espresso
(coffee or tea).
The display will indicate the number of the water dose being set
(water 1, water 2, etc.) and the water value blinking. In order to
verify the correspondence between the water doses refer to the
“Selection dose table”.

Necta Kobalto Specifications

General

Brand	Necta
Model	Kobalto
Category	Coffee Maker
Language	English