NeoDen 7 - Page 3

Hangzhou NeoDen Technology Co.,Ltd.
2.4.3.2 Inspection method
...................................................................................
27
2.4.3.3 Inspection standard
..................................................................................
27
2.5 Continuous SMT production
.........................................................................................
28
3.Structure and maintenance instruction
.....................................................................................
29
3.1 Structure chart
...............................................................................................................
29
3.2 Feeder Brief Introduction
..............................................................................................
30
3.3 Installing tape and reel components
..............................................................................
31
3.4 Incorrect installation Samples
.......................................................................................
32
3.4.1 Nozzle
.................................................................................................................
33
3.5 Maintenance
..................................................................................................................
35
3.5.1 Take effective measures to reduce /avoid malfunction
......................................
35
3.5.1.1 Reinforce daily maintenance
...................................................................
35
3.5.1.2 Requirements for operator
......................................................................
35
3.5.1.3 Formulate the measures to reduce/avoid big problem
............................
36
3.5.2 Maintenance
.......................................................................................................
36
3.5.2.1 Daily Inspection
......................................................................................
36
3.5.2.2 Monthly Inspection
.................................................................................
37
3.5.3 Related issues during solder paste printing process
..........................................
37
3.5.3.1 Stencil Printing Technology
.....................................................................
37
3.5.3.2 Inspecting of solder paste printing
..........................................................
37
3.5.3.3 The defects of solder paste printing, reasons andsolutions
....................
38