NeoDen 7 - Flow Chart of Making a Programming File; Edit on the Operation Interface; Edit on the Interface

Hangzhou NeoDen Technology Co.,Ltd.
4
1.4 Flow chart of making a programming file
Component setup
Select file and start
working
Start
Panelized PCB first chip setting
Edit the file
PCB feed setting
Fiducial setting
Feeder settings
Save and cancel
See P6
See P12
Pick up simultaneously
setting
See P18
See P5
See P4
Note: The basic procedure of making a programming file by manual programming or import
coordinate file is similar, but there are two different parts: component list and fiducial setting.
Please find the detailed operation steps of the differences on relative page
.
2.Edit on the Operation Interface
2.1 Edit on the Interface
See figure (2.1): On the file list interface, add a file and input the file name, select the file and
edit. Or edit the existed file.
Figure (2.1) is the edit interface