What to do if Neptune Technology ProCoder R900i indicates out of range reading (>99999999)?
If your Neptune Technology Media Converter indicates an out-of-range reading (greater than 99999999) and a diagnostic code from the MIU, it suggests that no meter reading history is available. To resolve this, swipe the MIU with a magnet to force it to read the register.
How to troubleshoot failure to retrieve reading on Neptune Technology ProCoder R900i?
If your Neptune Technology Media Converter fails to retrieve a reading, it usually indicates a cut wire. Check the connection between the register and the MIU. If you're using a non-auto-detect ProRead register, make sure it has been programmed for three-wire mode.
Details on transmit period, channels, frequency, output power, and FCC verification.
Guidelines for choosing an appropriate location for installing the ProCoder™)R900/™.
Step-by-step process for installing the ProCoder™)R900/™ on a new meter.
Procedure for replacing an existing register with the ProCoder™)R900/™.
Guidance on connecting an external antenna for pit installations.
Steps for physically installing the through-the-lid antenna onto the meter pit lid.
Instructions for connecting the antenna cable to the MIU housing.
Step-by-step guide on how to log data using the Hand-Held Unit (HHU).
Steps to initialize the data logger and verify time settings on the HHU.
Procedure for initializing the RF device.
Instructions for inputting the Meter Interface Unit (MIU) identification number.
Steps to start the RF-activated data logging process.
Explanation of various reading values and their troubleshooting implications.
General| Brand | Neptune Technology |
|---|---|
| Model | ProCoder R900i |
| Category | Media Converter |
| Language | English |
To Next Page