ProCoder™)R900i™ Installation and Maintenance Guide 19
Chapter 5: Data Logging Extraction
This chapter provides information about data logging.
About Data Logging
The ProCoder™)R900i™ stores interval data for data logging and retrieving this data
through RF activation. You activate the ProCoder)R900i using the Trimble
®
Nomad
®
and R900
®
Belt Clip Transceiver (BCT).
The ProCoder)R900i stores consumption in hourly intervals for a rolling total of 96
days, which is equal to 2,304 hourly intervals of consumption. The logged data can be
extracted through radio frequency (RF) activation. The RF activation allows the utility
workers to visit the location and extract the data without physically interacting with the
meter itself. This limits worker exposure to animals or dangerous situations. The
extraction process only takes about 30 seconds. You activate the unit through the
Hand-Held Unit (HHU) connected to the R900 BCT via Bluetooth
®
. The R900 BCT
sends the activation signal to the ProCoder)R900i which in turn sends the data intervals
to the R900. The data is saved in the HHU.
Accessing Data Logging
Complete the following steps to log data.
1. From the host software home screen on the HHU, click MENU.
Figure 14 – HHU Home Screen
To Next Page
Loading...
Need help?
General