Neptune Technology ProCoder R900i - Initializing RF Device; Entering MIU ID

4. Type your reader ID and password (if applicable) for the host software, and then
click LOGIN.
Figure 17 – Reader IDInput
Initializing the Data Logger
1. Verify the time is correct, and then click YES.
Figure 18 – HHU Time Confirmation
Synchronize the HHU prior to data logging to set the clock.
The Initialize screen appears if you are not connected or you are not in range of your
R900 BCT.
ProCoder™)R900i™ Installation and Maintenance Guide 21
Chapter 5: Data Logging Extraction