Glossary
S
seal pin
The small black plastic nail used to secure the ProCoder)R900i to the meter.
serial number
A unique identification number given to each MIU at the factory. The default value is the last
programmed plus one. Custom serial numbers are not available.
spud cap
Orange caps that are placed on the ends of a meter when shipping.
sweep hand
A sensitive dial that provides a visual representation of extreme low flows as well as reverse
flows.
T
transmission time
The time between the MIU transmissions. The default value is approximately 20 seconds.
Custom time is not available.
ProCoder™)R900i™ Installation and Maintenance Guide
37
To Next Page
Loading...