INTELLIGENT REACTIVE POWER MANAGEMENT
RM-12P
25
Press SET button to set Pin ACt parameter. Password can be set as
inactive or active.
In this menu, user password is changed. In order to change the password,
old password and new password (x2 times) must be entered.
3.12.b Pin Change
In order to define the new password, first of all, old password must be
entered. After entering the old password, press SET button.
SAUE
If you do not want to set another parameter, in order to quit from the
menu, press ESC button one by one until SAVE SEt yES is displayed.
Press SET button to save your changes or press ESC button to quit
without saving.
If you did not activate the password before, enter the pin code as 1234.
Press SET button to activate or inactivate the password.
Note: While entering the pin code, blinking digit represents that which
digit will be set. By using UP/DOWN buttons, value of the related
digit is increased or decreased. Press SET button to set next digit
or press ESC button to set previous digit.
By UP/DOWN buttons, Pin ACt parameter is selected as on or of
and then press SET button. If you do not want to set another parameter,
press ESC button.
In Pin ACt menu, press DOWN button to find Pin CHg menu.
Press SET button to change the password.
After entering new password, press SET button.
Note : If you do not save your changes, they will not be valid.
Note : If you do not want to set another parameter, in order to
quit from the menu, press ESC button sequencelly until SAVE
SEt yES is displayed. Press SET button to save your changes
or press ESC button to quit without saving.
To Next Page
Loading...
