17
Ness Guardpost Installation & Programming
PROGRAMMING
Navigation in program mode
Press the OFF button on a valid radio key to step
forward through the programming menu.
Select P-EXIT from the
programming menu.
Then press the ON button to
exit program mode.
Otherwise Guardpost will automatically
exit PROGRAM mode after 10 minutes of
inactivity.
Press the ON button to cycle through the sub-menu
options for a programming option.
Press the PANIC button to store the currently
displayed value. The new value will then ash to
indicate it is programmed.
The currently programmed value will ash.
The currently programmed value will ash.
Key 1
P-EXIT
Range
Range
Sens 1 Range Pulse Signal ...
Low HIGH
Low HIGH
The LEFT front panel button
cycles BACKWARD through
the programming menu.
To exit program mode
To Next Page
Loading...
