Ness Guardpost Installation & Programming Manual

7
Ness Guardpost Installation & Programming
Your Guardpost may be supplied with a factory-tted Ness GSM SIM card or install your own standard
SIM card as shown below.
Ness SIM cards are ready for use immediately. If using a third party SIM card ensure that it’s not PIN
locked.
The SIM access panel is on
the rear of the Guardpost.
Remove the lock screw to
open the access panel.
The GSM comms status LED, located in the SIM access panel, can be used to diagnose GSM network issues.
Insert the SIM card as shown
then secure the access panel.
GSM status LED
SIM CARD INSTALLATION
GSM STATUS LED
1 2
1. Insert the SIM card.
Note the position of the notch.
3. Slide forward to lock.
2. Close the SIM holder.
LED OFF GSM dialler disabled
One ash per second GSM network is not active
One ash every 3 seconds GSM network OK

Ness Guardpost Specifications

General

Brand	Ness
Model	Guardpost
Category	Security System
Language	English