31
Ness Guardpost Installation & Programming
AUDIBLE REPORTING OPERATION
If enabled, Guardpost reports alarms by audible message to up to two telephones via
the GSM network.
Audible Report
Guardpost is able to report alarms to one or two telephone/mobile phones via the
GSM network with audible messages, such as “ALARM FROM SENSOR ONE”,
“MEDICAL ALARM KEY TWO”, “PANIC ALARM KEY THREE” etc. Multiple voice
messages will be played if more than one event occurs while reporting.
There are 2 phone numbers, a primary number PHONE1 and a secondary number
PHONE2. Reports are usually sent on the primary number but if the dialler report is
not acknowledged, it will dial the secondary number. Telephone numbers must be
programmed into the system.
If no acknowledge is received from the number called, GUARDPOST re-try for a total
of 10 attempts before displaying a dialler fault. Then, it will try again in 5 minutes,
then, another 4 times every 1 hour. If still unsuccessful, GUARDPOST ceases
transmitting until a new event occurs and raises a system alarm.
ACKNOWLEDGE
Press key ‘9’ on the receiving telephone to acknowledge the audible report.
Guardpost will then hang up the call.
Or press ‘*’ to acknowledge the audible report and start Two-Way-Voice monitoring.
See page 32, Two Way Voice Monitoring.
GSM
Voice Message
“ALARM FROM
SENSOR ONE”
To Next Page
Loading...
Need help?
General
