All rights reserved. No part of this publication may be reproduced, transmitted or stored in a retrieval system in any form or by any
means, electronic, mechanical, photocopying, recording, or otherwise, without the prior written permission of Ness.
Ness reserves the right to make changes to features and specifications at any time without prior notification in the interest of ongoing
product development and improvement.
© 2012 Ness Corporation Pty Ltd ABN 28 069 984 372
NSW Ph 02 8825 9222 VIC Ph 03 9875 6400 QLD Ph 07 3399 4910 WA Ph 08 9328 2511 SA Ph 08 8152 0000
sales@ness.com.au nessmelb@ness.com.au nessbris@ness.com.au nessper@ness.com.au adelaide@ness.com.au
Innovative Electronic Solutions
www.ness.com.au
WARNINGS & NOTICES
Ness Corporation manufacturing processes are accredited to ISO9001 quality standards and all possible care and diligence has been
applied during manufacture to ensure the reliable operation of this product. However there are various external factors that may impede
or restrict the operation of this product in accordance with the product’s specification.
These factors include, but are not limited to:
1. Erratic or reduced radio range (if radio accessories are installed). Ness radio products are sophisticated low power devices, however
the presence of in-band radio signals, high power transmissions or interference caused by electrical appliances such as Mains
Inverters, Wireless Routers, Cordless Phones, Computers, TVs and other electronic devices may reduce radio range performance.
While such occurrences are unusual, they are possible. In this case it may be necessary to either increase the physical separation
between the Ness receiver and other devices or if possible change the radio frequency or channel of the other devices.
2. Unauthorised tampering, physical damage, electrical interruptions such as mains failure, electrical spikes or lightning.
3. Solar power inverters are a known source of electrical interference. Please ensure that this product and all associated cabling is
installed at least 3 metres away from a solar power inverter and its cabling.
WARNING: Installation and maintenance to be performed only by qualified service personnel.
CAUTION: Risk of explosion if battery is replaced by an incorrect type. Dispose of used batteries in accordance with local regulations.
Guardpost Installation & Programming Manual
Rev1.2 May 2012
Document Part No: 890-337
This document is for use with
Guardpost / SecurityGuard III models
shown.
Features and options not supported by
some models can be ignored during
programming and operation.
Radio Frrequency
Language
Radio Keys Supplied
Listen-in Dialler
SMS Send
SMS Receive
Radio Siren support
Solar Charging support
Ness SIM Card supplied
Two Way Voice
Audible Monitoring
100-275 Securityguard III GSM C-Protocol 304MHz
English RK3
8 4 4 4 4 8 8 8
100-281 Securityguard III GSM N-Protocol 304MHz
English RK3
8 4 4 4 4 8 8 8
106-285 Ness Guardpost TWV No SIM 304MHz
English RK4
4 4 4 4 4 8 4 4
106-286 Ness Guardpost TWV with SIM 304MHz
English RK4
4 4 4 4 4 4 4 4
100-279 Securityguard III GSM Europe 868MHz
English RK4
4 4 4 4 4 8 4 4
101-425 Securityguard III GSM TWV Portugal 868MHz
Portugese RK4
4 4 4 4 4 8 4 4
106-298 Securityguard III GSM TWV Italy 868MHz
Italian RK4
4 4 4 4 4 8 4 4
To Next Page
Loading...
Need help?
General
