Ness R16 User Manual

NESS R16 CONTROL PANEL - USER MANUAL
11
Monitor mode allows you to Arm selected zones
while others are ignored. Typically, perimeter
zones (doors and windows) can be monitored
while you are at home.
Your installer must program which zones will be
active in Monitor mode.
The panel must initially be in the disarmed
state and not in Program, Monitor, Memory or
Exclude modes.
Entry and Exit delay timers operate as normal
in Monitor Mode.
If an alarm occurs while in Monitor mode,
entering
[User Code]
will silence the alarm.
This will also Disarm the panel, so remember to
enter monitor again if needed.
Using the optional Radio Keys you can enter
Monitor Mode by pressing the ON button twice
within 4 seconds.
OPERATION
x 2
[User Code]
MONITOR MODE
...or
Ensure the system is disarmed before attempting
to arm in Monitor Mode.
To arm in Monitor Mode using a Radio Key,
press the ON button twice within 4 seconds.
If Siren Chirps have been enabled by
your installer, the strobe light output will
flash and the onboard siren will 'chirp' once
to indicate successful arming in Monitor
Mode.
The Monitor Mode Shortcut is enabled by default,
this allows arming of Monitor Mode without having
to enter your user code.
( can be disabled by
your installer).
Monitor Mode Shortcut

Ness R16 Specifications

General

Brand	Ness
Model	R16
Category	Control Panel
Language	English