20 • Quick Start Guide Element Manager User’s Manual Nimbra OneSerie
©2006 Net Insight AB, All rights reserved
Configuration
These procedures will set the basic parameters of the Nimbras. For a basic
configuration, keep the following information at hand:
Parameter name Description Type
System name The name of the unit, to be used instead
of the IP address, for easier recognition
in the web page.
Opt
Location Description of the location of the unit. Opt
Contact person The name or e-mail address of the
contact person for the unit.
Opt
DTM address Shows the DTM address of the node. Man
Type definitions: Man – mandatory, Rec – recommended, Opt – optional
Set the System Parameters
1. Navigate to the Maintenance|System page, Figure 7 will appear.
Figure 7. The Maintenance, System page
2. Enter the System name, the name of the Contact person and the Location.
3. If Events should be logged tick the appropriate boxes and enter the Event
and Alarm log size.
4. To make parameters active without leaving the page, click Apply. Any
changes will then be made effective immediately. To return to the
Maintenance page, click OK.
Set the DTM address
1. Navigate to the web page DTM|Addresses and click on the Add address
button. The Add page, Figure 8, will appear.