Element Manager User’s Manual Nimbra OneSerie Quick Start Guide • 23
©2006 Net Insight AB, All rights reserved
• Area number: In a large network all the nodes can not belong to the same
area. Configure the area it should belong to.
• Detect from neighbors: The node will receive the area number from the
neighbor.
3. Enter the Node metric and select Enable.
4. If one of the interfaces is more critical to use than the other, enter a metric
for the DTM interface.
5. Select if the node should be a switch or an end node.
6. Click OK.
7. Save the new configuration.
Save the configuration
1. Navigate to web page Maintenance|Configurations and click on the Save
configuration button. The Save page, Figure 12, will appear.
Figure 12. Backup of the configuration
2. Enter a suitable name in the Name field, and a description of the
configuration in the Description field. Make sure that the Valid checkbox is
ticked. Click OK.
Restart the system
1. Navigate to web page Maintenance|System. The System page, Figure 13,
will appear.