CONNECTING TO FROSTIE
Digital inputs Solenoid contacts Relay contacts
Two-wire solenoids use only the Red and Black terminals, and the White (common) is left empty. Three-wire solenoids use all three
terminals. FROSTIE does not use the Digital inputs.
The cable passes through the gland on the side of the case, which is sealed with a cap to protect the circuit board from dust and
moisture.
1. Unscrew and remove the lid of the case.
2. Remove the gland cap and slide it onto the solenoid cable.
3. Feed the solenoid or relay cable through the gland into the case.
4. Locate the relevant screw terminals on the circuit board.
5. Connect the leads as shown above and tighten the screw terminals.
6. Slide the gland cap onto the gland and tighten it.
7. Install batteries (see page 15).
8. Set and test the solenoid / relay output device (see page 17).
9. Replace the lid and tighten the screws to seal the case.
ln1-
ln1+
ln2-
ln2+
COM
CLS
OPN
White (com)
Black (close)
Red (open)
15
To Next Page
Loading...
Need help?
General
