INSTALLATION FOR FROSTIE
First you must put FROSTIE into FROSTIE mode:
Go to the Alarm menu and hold down the EXIT button for at least 3 seconds.
FROSTIE will display its current mode and will allow you to change it:
FROSTIE mode: HeatGARD mode: Dual HeatGARD mode
If necessary, Use or
buttons to set FROSTIE to FROSTIE mode:
After setting FROSTIE mode, press ENTER to view the current output
device. Use the or
buttons to change it. Press ENTER when done.
Note: the Aquanet setting is for solenoids which require more time than usual to activate. This setting will consume more battery
power.
Testing the Alarm Output Device (solenoid or relay)
1. Go to the Alarm menu and press the ENTER button. FROSTIE will display its current alarm mode: Off, Auto, or On.
2. To change alarm modes, hold down the or
button for three seconds, until the new alarm mode display stops flashing.
Alarm Output Off: Alarm Auto mode: Alarm Output On:
3. Swap between On mode and Off mode to force the alarm output to turn on or off. (It may take many seconds to build up enough
charge to fire the output on or off, during which time you can press the EXIT button to watch the charge voltage as it reaches 12V.
Then repeat from step 2.)
4. If FROSTIE detects a wiring problem when firing the solenoid, it will display one of the error messages described on page 12. If
so, check all connections or it might be necessary to change the Output Device (as shown above). Repeat testing until satisfied.
18
To Next Page
Loading...
Need help?
General
