Enter Local IP Address, Subnet Mask and Remote IP Address as provided by your ISP.
Configure the IPv6 WAN Settings as per your ISPs requirements.
Click Apply Changes.
To connect using a PPPoE connection:
From the Channel Mode drop down list, select PPPoE.
Select Enable NAPT.
From the Connection Type drop down list, select VOICE_INTERNET_TR_069.
From the IP Protocol drop down list, select IPv4/IPv6.
Enter the PPPoE Authentication Username and Password provided by your ISP.
Configure the IPv6 WAN Settings as per your ISPs requirements.
Click Apply Changes.
Configuring a Bridged connection:
From the Channel Mode drop down list, select Bridged.
From the Connection Type drop down list, select VOICE_INTERNET_TR_069.
Click Apply Changes.
Load your PPPoE client software on your PC and follow its set up instructions.
To Next Page
Loading...
Need help?
General
