NetComm Wireless NF15ACV

26
NetComm Wireless VDSL/ADSL Dual Band AC1200 WiFi Gigabit Modem Router with VoIP
www.netcommwireless.com
UM-00019 v1.0
WAN
Ethernet WAN
This section discusses how to configure your NF15ACV to use the WAN port to connect to the Internet.
To connect to the Internet using DHCP:
From the Channel Mode drop down list, select IPoE.
Select Enable NAPT.
From the Connection Type drop down list, select VOICE_INTERNET_TR_069.
From the IP Protocol drop down list, select IPv4/IPv6 for IPv6 dual stack, else select IPv4.
From the WAN IP Settings Type settings, select DHCP.
Configure the IPv6 WAN Settings as per your ISPs requirements.
Click Apply Changes.
To connect to the Internet using a Fixed IP:
From the Channel Mode drop down list, select IPoE.
Select Enable NAPT.
From the Connection Type drop down list, select VOICE_INTERNET_TR_069.
From the IP Protocol drop down list, select IPv4/IPv6.
From the WAN IP Settings Type settings, select Fixed IP.