NetComm Wireless NF15ACV User Manual

52
NetComm Wireless VDSL/ADSL Dual Band AC1200 WiFi Gigabit Modem Router with VoIP
www.netcommwireless.com
UM-00019 v1.0
Enter the details as required. A description of each field is listed in the table below. Click the Apply Changes button when
you have finished.
FIELD
DESCRIPTION
IP Version
Select IPv4 or IPv6.
Protocol
The selections are TCP, UDP, ICMP and blank for none. This field is required if the source port or destination port has been entered.
Source IP
The IP address of the source traffic.
Source Mask
The source IP netmask. This field is required if the source IP has been entered.
Destination IP
The IP address of the traffic destination.
Destination Mask
The destination IP netmask. This field is required if the destination IP has been entered.
Source Port
The source port of the select protocol. You cannot configure this field without entering the protocol first.
Destination Port
The destination port of the selected protocol. You cannot configure this field without entering the protocol first.
Uplink Rate
Enter a figure in kilobytes per second to restrict the uplink rate. Leave this blank for no restriction.
Others
Here you can configure IP passthrough. Select the interface then enter a lease time in seconds.
IPv6
IPv6
This page is used to enable or disable IPv6.

NetComm Wireless NF15ACV Specifications

General

Brand	NetComm Wireless
Model	NF15ACV
Category	Network Router
Language	English