Diagnostics
Ping
When troubleshooting your internet connection, it is a good idea to make sure you can ping the network. A ping command sends a
message to the host you specify. If the host receives the message, it sends messages in reply. To use it, you must know the IP
address of the host you are trying to communicate with and enter the IP address in the Host Address field. Enter the IPv4 or IPv6
host address in the appropriate field then click “Go!” to start the ping command. The ICMP ping results are displayed on this page.
Tracert
The Tracert (or trace route) command displays the hops that a message takes when it travels from your router to a remote
destination. Enter the host address that you wish to trace and click the “Go!” button. This allow you to identify the route taken for a
packet from your router to arrive at its destination.
ATM Loopback
Connectivity verification is supported by the user of the ATM OAM loopback capability for both VP and VC connections. This page
is used to perform the VCC loopback function to check the connectivity of the VCC.
To Next Page
Loading...
Need help?
General
