Optional Step 5: Install SFP or SFP+
transceiver modules
The following optional procedure describes how to install an optional SFP or SFP+
transceiver module into one of the SFP or SFP+ ports of the switch.
Note: Contact NETGEAR to purchase these modules. If you do not want to install an
SFP or SFP+ module, skip this procedure.
The following table shows the models and the ports that can support SFP or SFP+
modules.
Table 10. SFP or SFP+ port
Port NumbersType of PortModel
11 and 12SFPM4250-10G2F-PoE
11 and 12SFP+M4250-10G2XF-PoE+
11 and 12SFP+M4250-10G2XF-PoE++
13 and 14SFP+M4250-12M2XF
1 through 16SFP+M4250-16XF
For information about the SFP and SFP+ modules that are support, see Transceiver
modules and cables for SFP and SFP+ fiber ports on page 25.
Hardware Installation Guide37Installation
AV Line of Fully Managed Switches M4250 Series