NETGEAR AV Series Hardware Installation Guide

Additional troubleshooting suggestions
If the suggestions in the troubleshooting chart do not resolve the problem, see the
following troubleshooting suggestions:
•
Network adapter cards. Make sure that the network adapters that are installed in
the computers are in working condition and the software driver was installed.
•
Configuration. If problems occur after you alter the network configuration, restore
the original connections and determine the problem by implementing the new
changes one step at a time. Make sure that cable distances, repeater limits, and
other physical aspects of the installation do not exceed the Ethernet limitations.
•
Switch integrity. If necessary, verify the integrity of the switch by resetting it. To
reset the switch, turn the power On/Off switch to the Off position, disconnect the
AC cable, reconnect the AC cable, and then turn the power On/Off switch to the
On position. If the problem continues, contact NETGEAR Technical Support. For
more information, visit the support website at support.netgear.com.
•
Autonegotiation. The RJ-45 ports negotiate the correct duplex mode, speed, and
flow control if the device at the other end of the link supports autonegotiation. If the
device does not support autonegotiation, the switch determines only the speed
correctly, and the duplex mode defaults to half-duplex.
Hardware Installation Guide45Troubleshooting
AV Line of Fully Managed Switches M4250 Series

NETGEAR AV Series Specifications

General

Model	AV Series
Switching Capacity	Varies by model
Quality of Service	Yes
Jumbo Frame Support	Yes
Energy Efficient Ethernet	Yes
Ports	5, 8, 16
Layer	Layer 2
Mounting	Desktop
Speed	Gigabit Ethernet
Power Budget	Varies by model
Fanless Design	Yes