NETGEAR AV Series Hardware Installation Guide

Features
The switch supports the following key hardware features:
•
Switch ports and PoE support in various configurations depending on the model:
- M4250-10G2F-PoE+. Eight PoE+ 1GBASE-T RJ-45 ports, two 1GBASE-T RJ-45
ports, and two 1G SFP fiber ports. The total PoE budget for the switch is 125W.
- M4250-10G2XF-PoE+. Eight PoE+ (802.3at) 1GBASE-T RJ-45 ports, two
1GBASE-T RJ-45 ports, and two 10G SFP+ fiber ports. The total PoE budget for
the switch is 240W.
- M4250-10G2XF-PoE++. Eight PoE++ (802.3bt) 1GBASE-T RJ-45 ports, two
1GBASE-T RJ-45 ports, and two 10G SFP+ fiber ports. The total PoE budget for
the switch is 720W.
-
M4250-12M2XF. Twelve 2.5GBASE-T RJ-45 ports and two 10G SFP+ fiber ports.
-
M4250-16XF. Sixteen 1G/10G SFP+ fiber ports.
Note: 1GBASE-T ports also support 10M and 100M speeds. 2.5GBASE-T ports also
support 1G and 100M speeds.
•
Support for switching fabric up to 360 Gbps, depending on the model, with all ports
at line-rate.
•
One out-of-band (OOB) 1G Ethernet RJ-45 port.
•
One RS-232 RJ-45 console port.
•
One USB Type-C console port.
•
One USB 2.0 port for connection to a storage device.
•
Full-width, 1U chassis.
•
Full compatibility with IEEE standards:
- IEEE 802.3 (Ethernet )
- IEEE 802.3i (10BASE-T)
- IEEE 802.3u (100BASE-TX)
- IEEE 802.3ab (1000BASE-T)
- IEEE 802.3bz (2.5GBASE-T)
- IEEE 802.3z (1000BASE-SX/LX)
- IEEE 802.3ae (10GBASE-SR, 10GBASE-LR)
-
IEEE 802.3x Full-duplex flow control
Hardware Installation Guide7Introduction
AV Line of Fully Managed Switches M4250 Series

NETGEAR AV Series Specifications

General

Model	AV Series
Switching Capacity	Varies by model
Quality of Service	Yes
Jumbo Frame Support	Yes
Energy Efficient Ethernet	Yes
Ports	5, 8, 16
Layer	Layer 2
Mounting	Desktop
Speed	Gigabit Ethernet
Power Budget	Varies by model
Fanless Design	Yes