4.
If you attach a computer or workstation, configure the terminal emulation program
to use the following settings:
•
Baud rate. 115,200 bps
•
Data bits. 8
•
Parity. None
•
Stop bit. 1
•
Flow control. None
After you connect a console to the switch, you can configure the switch. For
information about configuring the switch using the command-line interface (CLI),
see the CLI manual, which you can download by visiting
www.netgear.com/support/product/m4250.aspx#download.
For information about configuring the switch through the main local browser user
interface (main UI) or the audio-video (AV) local browser user interface (UI), see the
users manuals, which you can also download by visiting
www.netgear.com/support/product/m4250.aspx#download.
Hardware Installation Guide41Installation
AV Line of Fully Managed Switches M4250 Series
To Next Page
Loading...
