Getting Started
12
Insight Managed 8-Port Gigabit Ethernet Smart Cloud Switch with 2 SFP Fiber Ports
8. Double-click GCmodel (xx:xx:xx:xx:xx:xx) (where GCmodel is the model number of your
switch and xx:xx:xx:xx:xx:xx is the MAC address of the switch).
The login page of the local browser interface opens.
9. Enter the password.
The default password is password. If you added the switch to a network on the Insight
app before and you did not yet change the password through the local browser interface,
enter your Insight network password.
10. Click the Login button.
A notification displays.
11. Click the OK button to close the notification.
The System Information page displays. The IP address of the switch displays on the
System Information page.
12. Write down the IP address for future use.
13. Select the PC Web-browser radio button.
14. Click the Apply button.
Your settings are saved.
The System Information page closes, any current Insight-manageable device settings are
saved to the cloud server, and the login window displays again.
15. When prompted, enter the password.
The default password is password. If you added the switch to a network on the Insight
app before and you did not yet change the password through the local browser interface,
enter your Insight network password.
The System Information page displays and the full local browser interface is now
available.
Access the Switch On-Network from a Mac
 To use a Mac and web browser to access the switch that is connected to a network:
1. Cable the switch to a network with a router or DHCP server that manages IP addresses.
2. Power on the switch.
The DHCP server assigns the switch an IP address.
3. Connect your computer to the same network as the switch.
You can use a WiFi or wired network connection.
4. Open the Safari browser.
5. Select Safari > Preferences.
The General page displays.
6. Click the Advanced tab.
To Next Page
Loading...
Need help?
General
